Tony Gutierrez

Using the WebUI or LinkDesk to unpair a mobile device. To unpair a mobile device in the WebUI:To unpair a mobile device you have to have its Link Mode in Mic and IEM settings set to None. To unpair...

DEVICES: Can we use network switches for the antenna ports?  No. Antenna ports are used in star topology with the Base Station in the center. This decision has been made due to the challengin...

RF: What bandwidths does Spectera support?  Spectera utilizes 6MHz or 8MHz depending on the region of operation. How many frequency variants do you plan?  SEKs and Antennas (DAD) are available ...

AUDIO: Do SEK bodypacks always need to operate both audio directions? No. You can choose for each pack individually, if you want to use MIC, IEM or both. Which audio interface is preferred? We o...

GENERAL: How can I get in touch with Sennheiser?  By registering your Spectera in the Sennheiser Portal (my.sennheiser.com), you will receive notification for software updates and release n...

In this article we will discuss antenna spacing and diversity, and why it is important. Antenna DiversityAntenna diversity is used to improve signal reliability and reduce dropouts caused by interf...

The receiver has three different modes (mono, stereo and safety) that can be set to optimally adjust all parameters to the respective recording situation and make your work easier. The different mo...

Once your base station is updated to the most current firmware, and your base stations license has been activated, you are now ready to start creating a production. Creating a new productionClick C...

 Meaning of the LED The LED on the front of the Base Station indicates the following information.  Information on the display Basic information is shown on the display.  The display goe...

Once you have unboxed your base station and powered it on, there are several steps that must be completed before you can fully set up your system. After unpacking the Base Station, you must update ...