Philip Slopak
- Total activity 54
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 24
Articles
Recent activity by Philip Slopak-
XSW 1 Scan and Sync
Follow the instructions below for scanning for new frequencies and synchronising your transmitter and receiver in XSW 1 systems: Start off by turning on the receiver, and turning off all the tr...
-
TC Bar M not visible in Dante network
Scenario: Within a managed enterprise network environment, the TC Bar M is set to Split mode and connected to dedicated “Control” (Port I) / “Dante” (Port II) subnets/ domains. Dante Controller ...
-
Error when installing Sennheiser Control Cockpit (SCC)
In some cases, you might run into an issue opening Control Cockpit where Control Cockpit is not showing up properly and the services are not starting properly.The issue is due to IIS(Microsoft Info...
-
TCC2 - Camera tracking / beam data freezing
We recently released firmware version 1.8.10 for the TCC2 which should help with beam freezing during long term operation with camera system tracking. This update is now available within the Cont...
-
Wireless audio dropouts
Note: this article is not dependent on a specific wireless system model, but is rather designed as a general troubleshooting process - refer to your system's documentations for further details as...
-
XSW 2 Scan and Sync
Follow the instructions below for scanning for new frequencies and synchronising your transmitter and receiver in XSW 2 systems: To perform and autoscan and synchronization please try the follow...
-
Evolution Wireless G2, G3 and G4 systems - RF Scan and Sync Procedure
Follow the instructions below for scanning for new frequencies and synchronising your transmitter and receiver in EW G2, EW G3 and EW G4 systems: To Perform an Easy Scan Setup: Turn on you...